No edit summary |
No edit summary |
||
| Line 20: | Line 20: | ||
Also it can be printed in just a few hours which would be much faster than if you had to order and ship one. | Also it can be printed in just a few hours which would be much faster than if you had to order and ship one. | ||
[[ | ==Prototype== | ||
'''Bill Of Materials''' | |||
*3x #6 sheet metal screws @ $0.372 per screw | |||
'''Installation and Use''' | |||
* Install using #6 sheet metal screws or equivalent and slide wire holder over. | |||
==Files== | |||
{{Gallery | |||
|width=180 | |||
|height=135 | |||
|title= [[Printable Parts]] | |||
|Image:cone1.png|Outside Material Funnel Cone | |||
|width=180 | |||
|height=135 | |||
|title= [[Printable Parts]] | |||
|Image:cone.png|Inside Material Funnel Cone | |||
|width=180 | |||
|height=135 | |||
|title= [[Printable Parts]] | |||
|Image:ScrewwithHolder.png|Side view Screw with Holder | |||
|width=180 | |||
|height=135 | |||
|title= [[Printable Parts]] | |||
|Image:ScrewwithHolder1.png|Top view Screw with Holder | |||
|width=180 | |||
|height=135 | |||
|title= [[Printable Parts]] | |||
|Image:T5pulley.png| Main Drive Motor Pulley | |||
|width=180 | |||
|height=135 | |||
|title= [[Printable Parts]] | |||
|Image:T5_belt.jpg| T5 Drive Belt | |||
|width=180 | |||
|height=135 | |||
|title= [[Printable Parts]] | |||
|Image:Recyclebot auger.png| Recyclebot feeding auger | |||
}} | |||
Revision as of 15:30, 7 November 2016
Team
Nicholas Lanter Undergrad student, Computer Engineering
Logan Brueck Undergrad student, Mechanical Engineering
Project
Test Lead Holder
An open source wire lead holder that can be easily printed for any lab. Saving both time and money.
A commercial off the shelf wire holder would cost about $15, this holder will cost $1.29 to print. Also it can be printed in just a few hours which would be much faster than if you had to order and ship one.
Prototype
Bill Of Materials
- 3x #6 sheet metal screws @ $0.372 per screw
Installation and Use
- Install using #6 sheet metal screws or equivalent and slide wire holder over.
