No edit summary |
|||
| Line 24: | Line 24: | ||
'''Bill Of Materials''' | '''Bill Of Materials''' | ||
*3x #6 sheet metal screws @ $0.372 per screw | *3x #6 sheet metal screws @ $0.372 per screw | ||
*Approximately 70 grams of PLA or equivalent filament @$0.24 per gram. $1.70 | |||
Total Cost ~$2.07 | |||
'''Installation and Use''' | '''Installation and Use''' | ||
* Install using #6 sheet metal screws | * Install using 3x #6 sheet metal screws and slide wire holder over screws, then tighten. | ||
==Files== | ==Files== | ||
Revision as of 21:11, 7 November 2016
Team
Nicholas Lanter Undergrad student, Computer Engineering
Logan Brueck Undergrad student, Mechanical Engineering
Project
Test Lead Holder
An open source wire lead holder that can be easily printed for any lab. Saving both time and money.
A commercial off the shelf wire holder would cost about $15, this holder will cost $1.29 to print. Also it can be printed in just a few hours which would be much faster than if you had to order and ship one.
Prototype
Bill Of Materials
- 3x #6 sheet metal screws @ $0.372 per screw
- Approximately 70 grams of PLA or equivalent filament @$0.24 per gram. $1.70
Total Cost ~$2.07
Installation and Use
- Install using 3x #6 sheet metal screws and slide wire holder over screws, then tighten.
