Editing Wire Holder

[[File:Wire_holder_finalrev.jpg|thumb|right|Printed Wire Holder]]

[[File:Wire_holder_in_lab.jpg|thumb|right|Wire holder being used in an MTU undergrad electronic lab]]
==Team==

'''Nicholas Lanter'''
Undergrad student,
Computer Engineering

'''Logan Brueck'''
Undergrad student,
Mechanical Engineering

==Project==

'''Test Lead Holder'''

[http://3dprint.nih.gov/discover/3DPX-004032 CLICK HERE FOR SOURCE FILES]

An open source wire lead holder that can be easily printed for any lab. Saving both time and money.

A commercial off the shelf wire holder would cost about $15, this holder will cost $2.03 to print and mount.
It can be printed in just a few hours which would be much faster than if you had to order and ship one.

==Prototype==

'''Bill Of Materials'''
*3x #6 sheet metal screws @ $0.11 per screw
*Approximately 70 grams of PLA or equivalent filament @$0.24 per gram. $1.70

Total Cost ~$2.03
[https://www.adafruit.com/product/2624 Versus $15 Pomona Holder]

'''Print Settings and Instructions'''
* Printing with 2 perimeters and 3 top and bottom layers with 20% infill delivers high quality and strong results.

'''Installation and Use'''
* Install using 3x #6 sheet metal screws and slide wire holder over screws, then tighten.

==Files==

<gallery>
Image:printable_wire_holder.JPG|Wire Holder Model
[http://3dprint.nih.gov/discover/3DPX-004032 Model Files]
</gallery>

{{Page data}}

[[Category:Devices]]
@@ Line 33: / Line 33: @@
 '''Print Settings and Instructions'''
-* 0.2 mm layer height
+* Printing with 2 perimeters and 3 top and bottom layers with 20% infill delivers high quality and strong results.
-* 2 perimeters
-* 3 top and bottom layers
-* 20% infill
-These settings will deliver good quality and strong results.
 '''Installation and Use'''