Smart motorized blinds: Difference between revisions

Introduction

Though there are many blinds on the market that come with motors, they are often very expensive and do not have automatic elements installed. It would be more cost-effective to install a custom motor attached to a circuit box able to control the tilt of manual blinds based on ambient settings. The goal of this project is to open the tilt of the blinds during the day and close them at night, allowing natural light to fill the house during the day and giving privacy in the evening. Additionally, these blinds will contain a temperature sensor to close the blinds if the interior becomes too warm.

Automatic motorized blinds should be put on the south windows in a North American household as the south facade has more sun exposure. This placement will ensure that the blinds operate at the right times and will be able to measure the temperature due to the sun exposure more accurately. With the motorized blinds installed, it will be much easier to decorate the interior of the test house with living plants, while also eliminating the need to manually open the blinds for daily demonstration purposes.

Smart Blind Design

The general design of the smart blind technology is based off of the schematic provided by a user on www.instructables.com named biochemtronics. Many of the components used in the original schematic were substituted to slightly different specifications, and to reduce shipping costs. One of the best designs for motorized blinds would be to create a box containing the circuitry and motor and simply attach the motor to the blinds via a hook. This will allow the smart blinds to be used on any set of venetian blinds.

In order to control a motor based on light and temperature readings, a microcontroller is needed. The PICAXE controller was chosen to be the optimal microcontroller after assessing the required functionality and cost. Though the cheaper PICAXE-08m would be satisfactory for this project, the PICAXE-18m2 model was chosen just in case more inputs would be needed for future alterations of the project.

There were two options to power the blinds: either to plug them into an electrical outlet via a transformer or to power it using batteries. To reduce the amount of installation required and the amount of wires needed for the design, the battery method was used. The PICAXE-18m2 microcontroller cannot support a voltage much higher than 5V, so if the batteries used exceeded 5V, a voltage regulator would be required. Using 4 AA batteries running through a 5V LM7805T voltage regulator powered the PICAXE controller, its outputs and the temperature sensor.

To make testing of the blinds easier, a 3.5mm Serial Jack was incorporated into the schematic so that the PICAXE controller could be reprogrammed while inside the motorized blind box. This jack can be accessed without opening up the box. In addition, two buttons were put into the schematic as a manual override to open and close the blinds. Lastly, a master switch was installed to save battery life when the blinds are not in use.

To make bullets use the asterisk:

• Like this
• and like this
  • and two for the next indent
• and back to one...

Project Goals

Describe project goals here.

To make a numbered list use the pound sign:

1. Like this
2. and like this
3. See Help:Contents for more formatting code.

Design

Describe your design here.

• Sample gallery
• 

  Sample caption text.

• 

  More sample caption text. This would look better with different images. :)

• 

  Even more sample caption text.

next level heading

You may need deeper level headings. Just keep adding equal signs to get that.

Costs

You may describe your costs here.

See Help:Tables and Help:Table examples for more.

Discussion

Your discussion.

Next Steps

The next steps.

Conclusions

Your conclusions.

References

Contact details

Add your contact information.