(→Method) |
No edit summary |
||
| Line 1: | Line 1: | ||
{{status-base|red|[[:Category:Status#Status:Design{{!}} designed]] but not yet tested - use at own risk.|Designs}} | |||
== Understanding the market == | == Understanding the market == | ||
| Line 16: | Line 18: | ||
** Nichrome wire placement | ** Nichrome wire placement | ||
** Channel for filament | ** Channel for filament | ||
== Design == | == Design == | ||
| Line 45: | Line 46: | ||
* 0.5mm pencil lead | * 0.5mm pencil lead | ||
* Electrical tape | * Electrical tape | ||
== Method == | == Method == | ||
| Line 63: | Line 63: | ||
File:pencilleadapplication.jpg|Pencil lead in place | File:pencilleadapplication.jpg|Pencil lead in place | ||
</gallery> | </gallery> | ||
== Discussion == | == Discussion == | ||
| Line 78: | Line 77: | ||
[[User:Raclark|Raclark]] ([[User talk:Raclark|talk]]) 14:43, 12 November 2015 (PST) | [[User:Raclark|Raclark]] ([[User talk:Raclark|talk]]) 14:43, 12 November 2015 (PST) | ||
[[Category:Projects]] | [[Category:Projects]] | ||
Revision as of 21:06, 3 May 2016
Understanding the market
A non-trivial cost of building a 3D printer is buying the hotend. In some parts of the world, the cost of importing hotends is prohibitive. Without considering the cost of shipping to remote areas of the world, a low-end hotend described as the "most affordable 3D printer hotend yet" retails for almost $32[1]. A hotend cast from silicone and nichrome wire in a printed PLA mold would significantly increase the availability of hotends in remote areas.
Project goals
This project seeks to design a 3D printed mold in PLA to cast a silicone based hot end, into which a nichrome wire can be inserted as a heating element.
Considerations include:
- Design of mold
- Choice of silicone
- Design of casting process
- Inserting silicone
- Nichrome wire placement
- Channel for filament
Design
The male and female molds were designed in FreeCAD to replicate an existing hot end design. The first iteration of hot ends were cast, but ultimately failed due to very long cure times and large trapped air bubbled. The improved method of producing the silicone body involves painting thin layers of silicone and letting it cure between each layer. While a more work intensive process, it leads to a much shorter cure time because the product is exposed to air.
-
Casting allows for large bubbles
-
Painting technique yields solid hot end
Parts
- Silicone
- Printed mold
- Male File:Malemoldhotend.stl
- Female File:Femalemoldhotend.stl
- Nichrome wire
- Thermistor
- 2 twisted pairs (not pictured)
Tools
- Soldering gun and solder
- Pin
- 0.5mm pencil lead
- Electrical tape
Method
- Obtain printed parts.
- Coat male mold in thin layer of silicone.
- Wrap nichrome wire around smallest barrel.
- Affix thermistor to nichome section with silicone.
- Use pin to place hole in end of male mold, insert 0.5mm pencil lead.
- Apply silicone layer by layer until the hot end rests confortably inside the female mold.
- Trim the length of 0.5mm barrel to about 2.5mm.
- Solder wires to nichrome wire and thermistor.
-
Single coat applied
-
Thermistor affixed
-
Pencil lead in place
Discussion
Use currently being investigated.