Sailing cam cleat

Cam Cleat

Project developed by Thomas Korejsza (talk) 16:55, 7 December 2015 (PST)

Template:Statusboxtop Template:Status-design Template:Status-prototype You can help Appropedia by contributing to the next step in this OSAT's status. Template:Boxbottom

Abstract

1) This OSAT design is an economical alternative for a cam cleat. Basic cam cleat designs are utilized for many functions. They are typically used as a quick release and locking mechanism for ropes and chords. These devices are usually found on sailing vessels as a method organize and hold lines. Additionally, with few modifications of this design, one being a pulley, a mechanical ascender should be able to be printed.

2) Cam cleats typically use leaf springs to provide their action, however, this is a prototype using rubber bands. The loads for this prototype need not be large to confirm how the rest of the design responds to an action.

3) Having the option to 3D print a cam cleat at sea is attractive as it can save frustration in the event of a failure. During light to medium wind conditions, a 3D printed cam cleat should be sufficient until a replacement can be obtained.

4) Picture of completed print using

File:File:OSAT Cam Cleat.jpg

Bill of Materials

1. Materials needed for fabrication of device and alternative materials if they are not available, prices/sources of non-printable parts
2. Plastic - roughly 66 grams of PLA which equates to $1.52 at $22.98 pr 1Kg.
3. Rubber bands- large assortated package at $1.68

   *ONLY NEED TWO BANDS!

1. Two 3mm bolts & Two 3mm Nuts ~ $0.98
   1. Upload and link to all source files from open source CAD
   2. Upload and link to all STLs

Tools needed for fabrication of the OSAT

1. MOST Delta RepRap or similar RepRap 3-D printer
2. C-clamps for setting nut into base plate.

Thomas Korejsza (talk) 16:55, 7 December 2015 (PST)

Skills and Knowledge Necessary to Make the OSAT

• Novice skill with OpenScad is required for the modeling.
• Knowledge of a cam cleat was required.

Technical Specifications and Assembly Instructions

1. Provide directions for print/assembly - be detailed enough in your “how to” to ensure that someone could construct the device from your description. Consider the elegance of IKEA like instructions.
2. print time estimate- 3 hours
3. Assembly time estimate 5-10 minutes
4. Including drawings or pictures of the device at stage of assembly at minimum. (http://www.appropedia.org/Special:Upload)

Common Problems and Solutions

• A common issue with this design is that the rubber bands providing the action may slip off when relaxed. This can be solved two ways, either provide a lip for them to stay on or use an exceptionally tight rubber band.
• Also, an improvement to this design would be a better stopping mechanism so the cam does not reverse on it self when relaxed.
• Both issues can potentially be solved when using a leaf spring instead of rubber bands.

Cost savings

1. Total cost using sum from BOM - $2.55
2. Commercial equivalent [Harken Cam Cleat] $31.50
3. $ savings = $28.55
4. % savings = %90

See also

• [[]]
• [[]]
• [[]]

External links

• []

Template:Stub

[[Category:]] [[Category:]]