(Created page with "{{MOST}} <!-- Comments that appear only in the edit view are formatted like this. --> <!-- These comments are offered as an aid as you get started. Remove as you wish. --> <!...") |
No edit summary |
||
| Line 9: | Line 9: | ||
==Introduction== | ==Introduction== | ||
Provide a background on the method - link to wikipedia or elsewhere. | <!-- Provide a background on the method - link to wikipedia or elsewhere.--> | ||
This recyclebot extrudes filament vertically. Material that is input into hopper must be granulated to ensure it will fit between auger and tube wall. | |||
==Safety== | ==Safety== | ||
*wear safety glasses (and dust mask if working with glass) while using recyclebot outside of a fume hood. these are not necessary if working under a fume hood. | |||
*when pushing material into hopper, make sure not to get your pushing utensil stuck in the auger. This will cause the recyclebot to stop and it is very difficult to remove utensil. | |||
==Equipment or Bill of Materials== | ==Equipment or Bill of Materials== | ||
*Recyclebot | |||
*Plastic or composite material (after wood chipper) should be in a plastic cup for ease of feeding into hopper | |||
*Knife/screwdriver/long thin bar shaped object for pushing material into hopper | |||
==Calibration & Tolerances== | ==Calibration & Tolerances== | ||
==Operation & Procedure== | ==Operation & Procedure== | ||
# | # plug recyclebot into wall | ||
# | # turn on recyclebot by flipping the "main" switch downward | ||
# | * note: DO NOT touch the "motor" switch until target temperature is reached!!! | ||
# | # set the temperature to the specific target temperature for your material | ||
# | # fill the hopper about halfway with your material and use pushing utensil to feed into auger | ||
# | # turn motor on by pressing "motor" switch downward | ||
# continue pushing material into auger and adding when hopper level gets low | |||
# when all material has gone through hopper (but some is still in auger) there is no need to continue pushing material through | |||
==Shutdown== | ==Shutdown== | ||
*turn off MOTOR FIRST | |||
*THEN turn off "main" | |||
*unplug | |||
== References == | == References == | ||
Revision as of 00:18, 22 October 2019
Introduction
This recyclebot extrudes filament vertically. Material that is input into hopper must be granulated to ensure it will fit between auger and tube wall.
Safety
- wear safety glasses (and dust mask if working with glass) while using recyclebot outside of a fume hood. these are not necessary if working under a fume hood.
- when pushing material into hopper, make sure not to get your pushing utensil stuck in the auger. This will cause the recyclebot to stop and it is very difficult to remove utensil.
Equipment or Bill of Materials
- Recyclebot
- Plastic or composite material (after wood chipper) should be in a plastic cup for ease of feeding into hopper
- Knife/screwdriver/long thin bar shaped object for pushing material into hopper
Calibration & Tolerances
Operation & Procedure
- plug recyclebot into wall
- turn on recyclebot by flipping the "main" switch downward
- note: DO NOT touch the "motor" switch until target temperature is reached!!!
- set the temperature to the specific target temperature for your material
- fill the hopper about halfway with your material and use pushing utensil to feed into auger
- turn motor on by pressing "motor" switch downward
- continue pushing material into auger and adding when hopper level gets low
- when all material has gone through hopper (but some is still in auger) there is no need to continue pushing material through
Shutdown
- turn off MOTOR FIRST
- THEN turn off "main"
- unplug