To Catch the Rain is the first book created from this much exclusive Appropedia content on rainwater. Thank you for making it happen! Get it digitally here or as paperback on Amazon.

Template:Topic with portal header

This article describes the types of common rainwater harvesters which are usable in practice and which can be built DIY. [1]Also, it provides some basic how-to content on how the harvesters can be built in practice. Rainwater harvesters are devices used to gather, or accumulate and store rainwater. [2]

Systems

There are many types of systems to harvest rainwater. Notable systems are systems for runoff rainwater (e.g. hillside run-off) and rooftop rainwater harvesting systems. The type used depends greatly on the purpose (domestic or industrial use) and to some extent also on economics and physical and human considerations. Generally speaking, rooftop rainwater systems are most used as they are most economical (if there is more than 254mm of precipitation a year)[3] To determine the amount of precipitation falling in your area, refer to Climate_data#Precipitation.

Domestic rooftop rainwater systems

System types

At the moment, 2 types of systems are generally used. These include DIY and commercial systems. Both of these systems are known under the term water harvesters and require only a limited amount of knowledge to set up (if basic systems are used). In both cases, the system consists of a storage tank to store the water and piping (to guide the water in). Additionally, extra pressuring equipment as pressure vessels, inline pump controllers or pressure sensitive pumps may also be required. [4] Finally, water purifying equipment as water-purifying plants, UV-lights or distillation equipment are sometimes (depending on local conditions [5] ) added to purify the collected water. The system is then called a Greywater treatment system. Greywater systems are usually preferred over regular water harvesters as they allow the system to not only treat the rainwater, but water from other sources as well (e.g. the watercloset; if plants are used). However, this feature may also be averted by using a UV-lamp and composting toilet instead.

Depending on local circumstances, a gravity-fed system may already be enough to have a pressured water collection system. [6] In the latter case, no pumps/pressure vessels are thus required to have a pressured system. In practice, gravity-controlled systems are usually created by placing the water harvester on an elevation (e.g. rooftops).

DIY domestic systems

As water conservation is becoming more and more popular, more people have begun to make their own homebrew installation. These systems range from traditional technologies like rain barrels to more complex greywater systems. Through the Internet, plans and accurate construction information have become available. [7] [8] [9] Depending on the degree of personal skill and preference, a more basic (regular water tank and piping[10]) -or more advanced (e.g. pressured systems with water treatment, etc.) system is chosen.

Commercial domestic systems

Commercial systems are also made. They are offered by a variety of companies ... Commercial rain harvesters can be obtained in both pressurized [11] as gravity-fed systems [12]. Greywater treatment systems are sold by companies as Nubian Water Systems, ... [13] Again, they are available in pressurised as gravity-fed systems.[14] [15]

System's operation

A mechanism can be used to send the initial water flow to waste, usually the first few liters. These are commonly known as first flush diverters, and are used to increase the chance that the large-particle residue that might accumulate on your collection surface is washed away from (and not into) your storage tank. Such a system also compensates for the fact that the initial minutes of a rainfall can include airborne pollutants being washed from the sky[verification needed], and likewise minimizes contamination of your captured supply. Simple but regular inspection and maintenance of such a device is usually necessary.

Not all catchment systems use such a feature. For example, rainwater in rural areas of Australia is traditionally used without such a system, and without treatment,[verification needed] but this may be unwise in different environments.

Practical use in autonomous houses/neighbourhoods

Most desert and temperate climates get at least 250 mm of rain per year. This means that a typical one-story house with a greywater system can supply its year-round water needs from its roof alone. In the driest areas, it might require a cistern of 30m³. Many areas average 13 mm of rain per week, and these can use a cistern as small as 10m³.

In many areas, it is difficult to keep a roof clean enough for drinking.[16] To reduce dirt and bad tastes, systems use a metal collecting-roof and a "roof cleaner" tank that diverts the first 40 liters. Cistern water is usually chlorinated, though reverse osmosis systems provide even better quality drinking water.

Modern cisterns are usually large plastic tanks. Gravity tanks on short towers are reliable, so pump repairs are less urgent. The least expensive bulk cistern is a fenced pond or pool at ground level.

Reducing autonomy reduces the size and expense of cisterns. Many autonomous homes can reduce water use below 10 US gal per person per day, so that in a drought a month of water can be delivered inexpensively via truck. Self-delivery is often possible by installing fabric water tanks that fit the bed of a pick-up truck.

It can be convenient to use the cistern as a heat sink or trap for a heat pump or air conditioning system; however this can make cold drinking water warm, and in drier years may decrease the efficiency of the HVAC system.

Industrial systems

Rainwater may also be used for groundwater recharge, where the runoff on the ground is collected and allowed to be absorbed, adding to the groundwater. In US, rooftop rainwater is collected and stored in sump.[17] In India this includes Bawdis and johads, or ponds which collect the run-off from small streams in wide area.[18][19]

In India, reservoirs called tankas were used to store water; typically they were shallow with mud walls. Ancient tankas still exist in some places.[20]

Successful Case Studies

See Portal:Rainwater

  • Petrolina, Brazil

Brazillimebig.jpg Climate: Semi Arid; Rainwater used as main source

Petrolina is in the semi arid belt of Northeastern Brazil. Rainfall is low and varies greatly year-on-year. A solution to the water-scarcity problem is the use of large (10,000-20,000 litre) tanks that can store enough water to last a frugal household until the next rains. The tanks are usually provided by NGOs as the large structures necessary in this very arid area cost over $200 and are unaffordable for the local population.

  • Badulla, Sri Lanka

Sritankbig.jpg Climate: Tropical, Bimodal ; Rainwater used as main source

The town of Badulla is located in a hilly area of Sri Lanka. Groundwater sources are few and tend to be at the bottom of the hills. To reduce the burden of carrying water the local authority provided 5,000 litre ferrocement tanks, at a cost of about $150 which are used for most household water supply. The tanks are now being adopted nationwide for use in areas where access to other protected water sources is difficult.

  • Rakai, Uganda

Fjarbig.jpg Climate: Tropical, Bimodal; Rainwater used as suplimentary source

Rakai is in the southern hills of Uganda. It has a bimodal rainfall pattern and hence a dry season of only 2 months. A local women's group was trained in tank making by a Kenyan women's group and have made a large number of small (700 litre) jars to supplement their water use, particularly in the wet season when they provide the bulk of water needs. The sub $70 cost of the systems are financed by a self sustaining revolving fund.

  • Khon Kaen, Thailand

Thaitankbig.jpg Climate: Tropical, Monsoon; Rainwater used as primary source

Northeast Thailand was the scene of one of the world's largest roof water harvesting disseminations. The technology of choice was the 1-2,000 litre "Thai jar" The project passed through several stages with reducing outside intervention, eventually becoming a commercial market producing jars in large numbers for less than $30. This encouraged rapid penetration of rainwater jars and today most houses, rich or poor, have at least one.[1]

International Rainwater Catchment Systems Association (IRCSA)

The purpose of the IRCSA aims to promote and advance rainwater catchment systems technology with respect to planning, development, management, science, technology, research and education worldwide; establish an international forum for scientists, engineers, educators, administrators and those concerned in this field. http://www.ircsa.org/

Primary Objectives of IRCSA

  • The promotion and advancement of Rainwater Catchment Systems Technology with respect to planning, development, management, science, technology, research and education world-wide.
  • The establishment of an International forum for scientists, engineers, educators, administrators and all others who are, directly or indirectly, concerned in rainwater catchment system programs to link all those working in this field so that information and experiences can be shared.
  • The drafting of international guidelines on the use of Rainwater Catchment Systems technology and the updating and dissemination of this information.
  • The collaboration with and support of International Programs in the field of Rainwater Catchment Systems including co-operation with other organizations having activities in common.
  • The support and continuation of the International Rainwater Catchment Systems Conference series.

Advantages of Rainwater Collection

  • Fairly inexpensive
  • Easy to reconfigure, expand, or relocate
  • Can be installed or expanded on a 'pay as you build' basis
  • Reliable
  • Water chemistry is easy to manage
  • Can be sized to the need at hand, and integrated into new construction easily
  • Extremely good back up system
  • Can easily be tied into well water system
  • Can be put inside a barn, large garage, or in a basement
  • Water is still available if you have no power
  • Pumps can run off solar or 12 volt systems
  • Tanks rarely freeze except in sustained extreme cold due to their thermal mass
  • Easy to tie into solar water system
  • Most of the system is accessible, so repairs are easy
  • Few expensive components

Disadvantages of Rainwater Collection

  • Aesthetically intrusive - you have to do something with big tanks
  • May not meet local building code requirements for primary water source for new construction
  • Requires more ground space than a well for the storage tanks and pumping system
  • Requires a good sized roof
  • Roof materials and airborne pollutants can pollute the rainwater
  • Gutters require constant maintenance and cleaning - http://www.thefarm.org/charities/i4at/surv/raincat.htm


Sources for more information

www.harvesth2o.com
www.rainwaterharvesting.tamu.edu
www.gardenwatersaver.com

References

  • International Rainwater Catchment Systems Association [2]
  • Appropedia Technology Library [3]

Interwiki links

Wikipedia: Rainwater harvesting

References

Template:Reflist

External links

Cookies help us deliver our services. By using our services, you agree to our use of cookies.