Line 98: | Line 98: | ||
=== Return to Main Page === | === Return to Main Page === | ||
[[Flock House Handcar Generator]] | [[Flock House Handcar Generator]] | ||
[[Category:Engr215 Introduction to Design]] | |||
[[Category:Flock House]] | |||
[[Category:Projects]] |
Revision as of 22:39, 3 December 2011
Introduction
The following is a brief overview of the steps the create your own Pump'n Power generator. Given the complexity of the design for this project, the finer details of the project are left to the builder to specify. Such details include the placement of supports, placement of the generator mounting point and plate, length of the pump lever, and method of attachment at each point.
Frame
To build the frame you will need two bicycles. At least one should have functionally rotating pedals, wheels, and crank at the bottom bracket. The need only contain a frame and handlebars as it will be referred to as the scrap bicycle and used as framing material. For the frame, most of the support pieces are welded to the main frame, while the rear support is mounted to the rear axle position thereby two rear bicycle frame components are mounted to the same rear axle.
Pump Lever and Crank Shaft
The pump lever is made up of steel square bar stock, a front bicycle wheel hub with quick release axle, two handle bars from the two bicycles, and the pedal that was removed earlier. The crank shaft is made up of round bar stock with an internal diameter that is the same as the diameter of the pedal material removed from the crank so that it can be inserted into the round bar and secured.
Generator
The generator is mounted below, and chained into, the rear cassette.