Open main menu

This is a property of type Text.

Showing 20 pages using this property.
1
The purpose of this tool is to quickly remove fasteners after they have been broken loose using a breaker bar or ratchet. This tool is meant to be used with 1/2" drive sockets.  +
A pill holder to hold daily pills for up to 14 days  +
2
Winnowing is a process to remove lighter particles of chaff, dirt, etc from grain and other products typically by throwing it into the air and blowing air on it.  +
3
This OSAT is a digital mass balance with two outputs: Digital output for data logging capabilities, and an LCD display.  +
This page contains the instructions and files necessary to 3D-print a loudspeaker.  +
A customizable open-source PV racking concept is designed, prototyped for three types of modules, constructed into systems, and outdoor tested under extreme conditions for one year. An economic analysis is provided along with a technical evaluation of the system.  +
A low-cost 3-D printable open source dual axis gimbal system is presented in this study. An Arduino based microcontroller is used to move the sample holder to the user specified angle where two stepper motors control the motion providing two degrees of freedom.  +
In order to ensure appropriate spacing and well oriented array these open-source photovoltaic spacers can be printed. The design has been created to be parametric in OpenSCAD so this design can be used for any conventional array.  +
This is a solar charger or an emergency light. It runs on a 6660 mAh battery.  +
An effective method for the diagnosis of severe acute malnutrition is the measurement of the middle upper arm circumference (MUAC).  +
This speculum takes a different design that current production models to eliminate the need for pivot hardware or large joints. The open jaw design allows for greater operating and inspection area.  +
The goal of the 3D-printable cider press is to provide an affordable means of efficiently pressing cider. With scaled-up designs, the press can be used to produce enough product to sell excess not used for subsistence.  +
Goniometers are simple devices used to measure the angular range of motion of human limbs. A 3D printed goniometer can be more durable than a commercial one. With the 3D printed version being so extremely cheap, patients can be provided their own goniometers to monitor their own range of motion, thus reducing expensive doctor's visits.  +
Small Bike seat and seat post that can be used to replace an original bike seat.  +
Carpenter knife  +
Print Out Custom T-Shirts at your Home right from your Desk with an Amazing 3D Printer!  +
This project was to replicate the already produced gravity light into the 3D Printed and open source world.  +
An otoscope is simple device used in the diagnosis of ear, nose, and throat diseases.  +
Open source design files provided for 3D printing of open-toed shoes. It is estimated that two billion people worldwide are currently plagued with parasitic diseases that could be prevented by wearing proper footwear.  +
One inexpensive way to add iron to a person's diet is to boil water for cooking with a lump of iron for 10 minutes before adding any food. Lucky iron totems composition must be monitored to ensure that toxic levels of elements are not going to be absorbed by the food cooked in the boiled water.  +