No edit summary |
No edit summary |
||
| Line 7: | Line 7: | ||
#. Change the print setup to custom. | #. Change the print setup to custom. | ||
#. Find "Material" Settings. | #. Find "Material" Settings. | ||
#. Change the "Diameter" to 1.75 as shown in the picture | #. Change the "Diameter" to 1.75 as shown in the picture [[Image:Cura screenshot.jpg|thumb|right]] | ||
Revision as of 19:49, 5 September 2019
Printing 1.75 mm filaments using 3 mm printers such as Lulzbot TAZ 6 and Lulzbot mini
- You can print with 1.75 mm filaments using printers which use 3 mm filaments by default.
- The page will describe the methods by just using software and both software and hardware to get even more better results.
Software Method
- This is a very simple method with which you only have to change software settings in Cura Lulzbot.
- . Change the print setup to custom.
- . Find "Material" Settings.
- . Change the "Diameter" to 1.75 as shown in the picture
