Get our free book (in Spanish or English) on rainwater now - To Catch the Rain.
Open-source simple semiconductor sample holder
| By Michigan Tech's Open Sustainability Technology Lab.
Wanted: Students to make a distributed future with solar-powered open-source 3-D printing.
This project is part of a collection on open source optics meant to radically reduce the cost of experimental optical equipment. See: Zhang C, Anzalone NC, Faria RP, Pearce JM (2013) Open-Source 3D-Printable Optics Equipment. PLoS ONE 8(3): e59840. doi:10.1371/journal.pone.0059840 open access
It should be noted that these sample holders can also be used to hold appropriately sized stationary mirrors. The sample holder consists of three components: the metal rod, the plastic base, and the sample clamp. The metal rod fits through the sample clamp and the sample clamp is held in place with a set screw. The sample clamp consists of three screws which tighten down to hold the two parts of the sample clamp together. The corner of the sample is pinched and held between the two parts of the sample clamp. From the picture, one can see that the sample is very exposed and is not blocked by the holder except on the bottom right. This gives flexibility to laser placement and allows for wide angles of incidence. The wide plastic base gives the whole setup stability and flexible placement.
This optical component is not designed to be fitted into an optical breadboard or lab bench. The advantage of this is that there is no limit to placement for the lens holder within the optical system. However, the disadvantage is loss of stability associated with an optical lab bench.
OpenSCAD and STL files: http://www.thingiverse.com/thing:28111
STL and max files: http://www.thingiverse.com/thing:30233
STL and max files: http://www.thingiverse.com/thing:30688