Obvious 3D printer technology based on 02. Extraction

This page was part of an MTU course MSE4777 OA and MSE4777 OB/MSE5777/EE4777/EE5777: Open-source 3-D printingPlease leave comments using the talk page. The course runs in the Fall semester. It is not open edit.Read more...

Bllafata (talk) 07:17, 1 December 2015 (PST) WayneHelminen (talk) 07:19, 1 December 2015 (PST)

1. Smart slicing based on the printer, uploading the model to the printer should slice and create the gcode locally. Bllafata (talk) 07:53, 1 December 2015 (PST)
2. Remove print head and use concentrated sunlight on a powder/gel to build the print WayneHelminen (talk) 07:52, 1 December 2015 (PST) Bllafata (talk) 07:32, 3 December 2015 (PST)
3. Remove the motors, replace the mechanical pulley system with electromagnets to move the belt up and down. Bllafata (talk) 07:51, 1 December 2015 (PST) WayneHelminen (talk) 07:53, 1 December 2015 (PST)
4. To make it safer, remove the hotend and print with foam (or other low temp materials)Bllafata (talk) 07:32, 3 December 2015 (PST)