No edit summary |
No edit summary |
||
| Line 118: | Line 118: | ||
|Standoffs located inside the chassis | |Standoffs located inside the chassis | ||
|4 | |4 | ||
|- | |||
|<div id="idler_end">[[File:tensioner.PNG|thumb|300px|center|'''Tensioner''']]</div> | |||
|Chain tensioner located in the middle of the Growbot chassis | |||
|2 | |||
|} | |} | ||
{{Template:OSHE_Growbot_Nav}} | {{Template:OSHE_Growbot_Nav}} | ||
Revision as of 19:12, 7 May 2020
This page is a photographic glossary of all of the 3D printed parts for the Growbot. All files can be found on our OSF repository. All parts were printed on a Prusa MK3s with black Atomic Filament PETg, infill was 20% and 0.2mm layer height.
| Part | Description | Count |
|---|---|---|
 |
Drive gear located on motor shaft. Inserted with a 3mm hex nut and bolt on side mount to tighten unit to the shaft. | 2 |
 |
Driven Gear located on axle assembly. Attached to wheel via 3mm hex nuts and bolts, compressed together within axle assembly. | 4 |
 |
Wheel located on the end of the axle assembly. Joins to the 72-tooth gear and is base for tire to mount onto. | 4 |
 |
NinjaFlex Tire with custom treads. Mounts onto wheel by sliding over ridges and held in place via friction. | 4 |
 |
Bearing Carrier for the entire axle assembly and is bolted directly into the aluminium extrusion via t-nuts. | 4 |
 |
Motor mount located on either side of GrowBot. Base for encoder mounts and support torque driven through the chassis. | 2 |
 |
Encoder Mounts on the end of both motors. Mount directly to the the motor mounts via 3mm bolts and heat inserted nuts. | 2 |
 |
E-Stop mount for easy access to disable robot movement in case of an emergency. | 1 |
 |
Rack and Pinion carrier for water sensor located on the outside of the Growbot. | 1 |
 |
Standoffs located on rear section of motor mounts to aid in connection to chassis. | 4 |
 |
Battery carrier that sits inside GrowBot chassis, bolts up directly to bottom plate. | 1 |
 |
Top cover of soil sensor that aids in keeping water-tight seal | 1 |
 |
Bottom cover of soil sensor that aids in keeping water-tight seal | 1 |
 |
PETG Bearing located in sensor rack cover | 1 |
 |
Mount for soil sensor motor | 1 |
 |
Drive gear for soil sensor asssmebly | 1 |
 |
Rack of assmebly that holds soil sensor and articulates down from Growbot | 1 |
 |
Cover for sensor rack components | 1 |
 |
Track for rack articulation | 1 |
 |
Inductor holder for the right sensor | 1 |
 |
Inductor holder for the leftsensor | 1 |
 |
Holds the wire of the sensor | 2 |
 |
Mount to connect sensor wire holder to the Growbot | 2 |
 |
Clip on relay holder located inside chassis of the Growbot | 1 |
 |
Measuring block utilized to position motors on the Growbot frame | 1 |
 |
Standoff for modules | 2 |
 |
Standoffs located inside the chassis | 4 |
 |
Chain tensioner located in the middle of the Growbot chassis | 2 |
