We continue to develop resources related to the COVID-19 pandemic. See COVID-19 initiatives on Appropedia for more information.

OSAT Jump Rope Design

From Appropedia
Jump to navigation Jump to search
OSAT Jump Rope Design
A_cranford_osat_jump_rope.JPG
Description This provides a cheap alternative for either single use or could be used to make a big jump rope for 3+ people at a time.
Intended use hobbyism
Keywords 3D printing, jump rope, game, exercise
Documentation language eng
Appropedia user User:Aaron.cranford
Project status prototype
Project was made Yes
Date of publication
Countries of design
Project affiliation
Main materials Plastic
Estimated cost 1.15
SDG Sustainable Development Goal 3
Hotend.JPG This page is part of a Principia course ENGR242: 3-D Printing Technology

Please leave comments using the discussion tab. The course runs in the Spring semester. It is not open edit.



Title of the device or system

Project developed by [your name linked to your user account]
Add a status meter by copying the following templates (inside double curly brackets) into your page as you reach each step: status-design, status-prototype, status-deployed, status-model and status-verified....
Status
This OSAT has been designed but not yet tested - use at own risk.
This OSAT has been prototyped.
This OSAT has been verified by: Aaron Cranford.

You can help Appropedia by contributing to the next step in this OSAT's status.

Abstract

Jump rope handles. What more is there to be said? Kids who need exercise and either can't go running or can't leave the house can use these handles if they find a rope. The idea came from the education tab in the UNICEF Supply Catalog where under physical education they had mostly kick balls which could be expensive to replace all the time because of constant use or if it were to get lost. This provides a cheap alternative for either single use or could be used to make a big jump rope for 3+ people at a time.

A cranford osat jump rope.JPG

Bill of Materials

You will need 35g of PLA filament. (About $1.15, varies on different suppliers) Media:a_cranford_jumprope_v3.FCStd

Tools needed for fabrication of the OSAT

  1. Jellybox or similar RepRap 3-D printer

Skills and Knowledge Necessary to Make the OSAT

None.

Technical Specifications and Assembly Instructions

When printing it's best to print the handles up-side down with the height at about 140mm (Z coordinate). It's safest to use a raft and print both at once to save time. It will take 4 hours and 8 minutes to print the both of them.

Common Problems and Solutions

Make sure to have a raft so it wont break off while printing.

Cost savings

It should cost around $1.15 for the filament. Most other jump ropes cost at least $2 You will be saving about 43% the cost.

... more about "OSAT Jump Rope Design"
This provides a cheap alternative for either single use or could be used to make a big jump rope for 3+ people at a time. +
3D printing +, jump rope +, game +  and exercise +
OSAT Jump Rope Design +