Multimeter Negative Probe Holder: Difference between revisions

Revision as of 21:44, 13 November 2019

This tool is used to hold the negative probe when reading voltages on motor control boards for the Athena2 3D printer. It could be modified to fit another printer setup. The model was created using FreeCAD.

Understanding the market

This product is complete and it functions as a negative probe holder. A video of it functioning can be found in the link below:

https://www.youtube.com/watch?v=eBmED1PZYD0&feature=youtu.be

Project goals

Item should hold the negative probe so that two hands are free to measure motor control board voltages.

Design

FreeCAD, STL and gcode files are attached:

https://www.myminifactory.com/object/3d-print-athena-2-multimeter-negative-probe-holder-104960

3-D Printable Parts

The entire tool is 3D printable.

@@ Line 3: / Line 3: @@
 <!-- Mark this as an MSE4777 page thru MTU -->
 {{777}}
-[[File:Fgaiken science.png|thumb|right|The first functional iteration of the balance.]]
+[[File:fgaiken_probeholder.jpg|thumb|right|This is a picture of the tool printed and attached to the 3D printer.]]
 ''This tool is used to hold the negative probe when reading voltages on motor control boards for the Athena2 3D printer. It could be modified to fit another printer setup. The model was created using FreeCAD.
@@ Line 10: / Line 10: @@
-This is the first iteration of the design. It still needs to be adjusted to correctly fit the printer bed.
+This product is complete and it functions as a negative probe holder. A video of it functioning can be found in the link below:
+https://www.youtube.com/watch?v=eBmED1PZYD0&feature=youtu.be
 == Project goals ==
@@ Line 19: / Line 20: @@
 == Design ==
-FreeCAD and STL files are attached:
+FreeCAD, STL and gcode files are attached:
+https://www.myminifactory.com/object/3d-print-athena-2-multimeter-negative-probe-holder-104960
@@ Line 25: / Line 28: @@
 The entire tool is 3D printable.
-== Progress ==
-st iteration FreeCAD and STL files are attached: