(Created page with "{{MOST}} ===Force Testing Protocol:=== DOES NOT NEED CALIBRATION #Set the raspberry pi to max current. #Only put the plunger of the syringe in the pump, not the entire syringe...") |
|||
| Line 1: | Line 1: | ||
{{MOST}} | {{MOST}} | ||
===Force Testing Protocol:=== | ===Force Testing Protocol:=== | ||
====Using an Instron 4206 Tensile Test Machine with a 10kN Load Cell==== | |||
DOES NOT NEED CALIBRATION | DOES NOT NEED CALIBRATION | ||
#Set the raspberry pi to max current. | #Set the raspberry pi to max current. | ||
Revision as of 15:50, 13 December 2013
Force Testing Protocol:
Using an Instron 4206 Tensile Test Machine with a 10kN Load Cell
DOES NOT NEED CALIBRATION
- Set the raspberry pi to max current.
- Only put the plunger of the syringe in the pump, not the entire syringe.
- Place the pump, motor down, in a tensile strength tester. Set height to be just above the pump.
- Then tell the pump to push past the top plate.
- Record the force given in Newtons.