Line 24: Line 24:


=== <font color="green">MOST RepRap version 1</font> ===
=== <font color="green">MOST RepRap version 1</font> ===
 
*New firmware installed (Marlin) in hopes of fixing connection issues [[User:Btwittbr|Btwittbr]] ([[User talk:Btwittbr|talk]]) 09:53, 28 February 2014 (PST)


=== <font color="orange">Type A Machines</font> ===
=== <font color="orange">Type A Machines</font> ===

Revision as of 17:53, 28 February 2014

This page is dedicated to the printers in the MOST lab that are used for production. Due to the number of people we have going in and out of the group and room, and the volume of printing we need, it is important to keep a log of what breaks, and what is fixed with each printer.

Instructions

  • Add yourself to the list of users on each printer you intend on using for a sustained period of time
  • When something breaks log it with the date, and what broke. If you don't know exactly what broke make a good guess.
  • Ensure that once the problem has been fixed you add fixed at the end of the problem summary and change the status of the printer
  • Do not remove information just because you fixed it. Keeping old information will help to document recurring problems.
  • Red: Completely out of commission.
  • Orange: Printing but with problems.
  • Green: Good to go.

Makerbot

  • Right extruder thermocouple can short causing incorrect temperature readings and stopping prints Btwittbr (talk) 16:48, 15 February 2014 (PST)
  • Removed from commission, turning into 4-point probe Btwittbr (talk) 09:52, 28 February 2014 (PST)

Lulzbot

  • Hot end and extruder are currently out of commission, new parts coming in Btwittbr (talk) 16:48, 15 February 2014 (PST)
  • New hotend installed, needs idler assembly before back up and running Btwittbr (talk) 09:52, 28 February 2014 (PST)

MOST Reprap (j-head)

  • Sporadic skipping in x-axis causing failed prints, failure is not repeatable Btwittbr (talk) 16:48, 15 February 2014 (PST)

MOST RepRap version 1

  • New firmware installed (Marlin) in hopes of fixing connection issues Btwittbr (talk) 09:53, 28 February 2014 (PST)

Type A Machines

  • The thermistor gives the wrong temp. reading in Pronterface so any gcode must have the printing temp at about 180
  • Do NOT adjust the base screws. Only adjust the bigger screw that controls the z-axis with slight movements.
  • Thermistor connection gets messed up and the printer stops extruding because the temp is too low. FIXED Emily Hunt (talk) 07:31, 18 February 2014 (PST)
  • Prints fine then keeps disconnecting for no apparent reason. FIXED Emily Hunt (talk) 10:40, February 2014 (PST)
  • Clogged. Emily Hunt (talk) 15:54, 25 February 2014 (PST)
Cookies help us deliver our services. By using our services, you agree to our use of cookies.