No edit summary
No edit summary
Line 15: Line 15:


=Introduction=
=Introduction=
{{gallery
|width=250
|height=250
|lines=1
|align = right
|Image:Dporter most delta.JPG|[Heated Bed Setup]
}}
This page describes my custom modifications to the MOST-Delta printer constructed at Michigan Technological University as part of the graduate level final project for [http://www.appropedia.org/MY4777 MY4777/MY5777/EE4777/EE5777 Open-source 3-D printing] .  During initial construction of the printer I was immediately planning modifications to help with better print quality and to allow for various printed materials.  Instead of a single modification I made multiple modifications to build my personalized printer to my specifications. Listed below are the list of modifications that were completed this semester:
This page describes my custom modifications to the MOST-Delta printer constructed at Michigan Technological University as part of the graduate level final project for [http://www.appropedia.org/MY4777 MY4777/MY5777/EE4777/EE5777 Open-source 3-D printing] .  During initial construction of the printer I was immediately planning modifications to help with better print quality and to allow for various printed materials.  Instead of a single modification I made multiple modifications to build my personalized printer to my specifications. Listed below are the list of modifications that were completed this semester:



Revision as of 05:36, 11 December 2014


Introduction

This page describes my custom modifications to the MOST-Delta printer constructed at Michigan Technological University as part of the graduate level final project for MY4777/MY5777/EE4777/EE5777 Open-source 3-D printing . During initial construction of the printer I was immediately planning modifications to help with better print quality and to allow for various printed materials. Instead of a single modification I made multiple modifications to build my personalized printer to my specifications. Listed below are the list of modifications that were completed this semester:

  • 203W Modified XBOX Power Supply
  • RepRap PCB MK2b heated bed
  • Borosilicate Glass Print Surface
  • Carbon Tie Rods
  • Aluminum Pulleys
  • ZeniKentics Spool mount

Bill of Materials


Source Files/ Links

Tools

  • Soldering Iron
  • Hobby Knife
  • Drill (w/ bits and drive set)
  • Allen Wrench Set
  • Dremel Tool
  • Hammer
  • Engineering Prowess

Consumables

  • PLA
  • Shrink Tube
  • Solder
  • JB Weld Epoxy
Cookies help us deliver our services. By using our services, you agree to our use of cookies.