| Line 51: | Line 51: | ||
*Shrink Tube | *Shrink Tube | ||
*Solder | *Solder | ||
[[category: MOST methods]] | [[category: MOST methods]] | ||
[[category:3D printing]] | [[category:3D printing]] | ||
Revision as of 21:50, 10 December 2014
!This page is work in progress!!!
Introduction
This page describes my custom modifications to the MOST-Delta printer constructed at Michigan Technological University as part of the graduate level final project for MY4777/MY5777/EE4777/EE5777 Open-source 3-D printing . During initial construction of the printer I was immediately planning modifications to help with better print quality and to allow for various printed materials. Instead of a single modification I made multiple modifications to build my personalized printer to my specifications. Listed below are the list of modifications that were completed this semester:
- 203W Modified XBOX Power Supply
- RepRap PCB MK2b heated bed
- Borosilicate Glass Print Surface
- Carbon Tie Rods
- Aluminum Pulleys
- ZeniKentics Spool mount
- Plexi Glass Print enclosure
Bill of Materials
- 203W Modified XBOX Power Supply-Free
- RepRap PCB MK2b heated bed-$12
- Borosilicate Glass Print Surface-$23
- Carbon Tie Rods w/ 3/8" ball berings-$3.50
- Aluminum Pulleys- $15
- ZeniKentics Spool mount- $350
- Plexi Glass Print enclosure- $8
Source Files
Tools
- Soldering Iron
- Hobby Knife
- Drill (w/ bits and drive set)
- Allen Wrench Set
Consumables
- PLA
- Shrink Tube
- Solder