| Line 135: | Line 135: | ||
|Image:Soldering semiconductor with heat sink connected to the solder.jpg |Photo by Team Stark | |Image:Soldering semiconductor with heat sink connected to the solder.jpg |Photo by Team Stark | ||
|3| Use heat sink for soldering semiconductors due to semiconductors' heat sensitivity | |3| Use heat sink for soldering semiconductors due to semiconductors' heat sensitivity | ||
|4| Soldering on the BVM1 circuit board complete | |||
|Image:Testing on car battery.jpg| Complete BVM1 | |||
|footer= | |footer= | ||
}} | }} | ||
Revision as of 22:51, 5 December 2011
Step by step instructions
Housing
| Material | Measurement |
|---|---|
| Sheet of aluminum | 7 ft X 3 ft |
| squared metal beam | 1ft length, 1/2 inch diameter and width |
| Woodfast roofing screw | 1 inch |
Image:Cut pieces.jpg
Meter's housing
Base (optional)
| Material | Measurement |
|---|---|
| 2 aluminum plates | 2 ft X 33 ft |
| 3 round rubber stoppers | radius of 1.5 inches |
| 2 rubber casters | radius of 3 inches |
| sliding gate wheel bracket | 2 ft by 4 ft |
| nuts and bolts | less than 3 inches |
Image:110411193799a.jpg
Meter's Base
Face
| Material | Measurement |
|---|---|
| 2 circular mirrors | radius of 3.5 inch |
| 2 steel ventilation adapters | 8 inch to 6 inch adapter |
| Plexiglass (Lexan* Polycarbonate sheet) | 6 inch circles |
| steel ventilation duct (color black) | radius of 4 inches |
| Blue LED lights | amount of 40 lights |
| Sheet metal screws | 1/2 inch long |
| Thermostat wire | 24 gauge wire (red and white) |
Image:Cutting glass.jpg
Meter's Base
Wiring from battery to Meter
| Material | Measurement |
|---|---|
| Aluminum electrical conduit | 1/2 inch width, 25 ft long |
| Thermostat wire | 24 gauge wire (red and white) |
Image:Empty circuit board.jpg
Circuit Board