Kathy Nativi (talk | contribs) No edit summary |
Sophivorus (talk | contribs) m (Text replacement - "|documentation-language=eng " to "|documentation-language=English ") |
||
Line 24: | Line 24: | ||
|main-materials= | |main-materials= | ||
|sustainable-development-goal= | |sustainable-development-goal= | ||
|documentation-language= | |documentation-language=English | ||
}} | }} | ||
<!--end infobox--> | <!--end infobox--> |
Revision as of 14:46, 17 July 2020
Title of the device or system
Handlebar grip for a bicycle developed by Abhijeet Divekar
Abstract
This part was built to meet the needs of one of our professors; Dr. Greshenson, that heads a bike Enterprise program at Michigan Tech.
Bill of Materials
- No additional materials needed. Open source softwares, computer and RepRap is all you need.
Tools needed for fabrication of the OSAT
- MOST Delta RepRap or similar RepRap 3-D printer
- OpenSCAD
- Slicing Software, like Cura or Slic3r
Skills and Knowledge Necessary to Make the OSAT
- No special skill(s) needed.
Technical Specifications and Assembly Instructions
No special instructions needed. Pretty straight-forward.
Common Problems and Solutions
- Include common mistakes/problems to avoid in building your OSAT and how to overcome them
Cost savings
- If your solution is not a low cost one then it is not really appropriate.
Typical handlebar grip costs anywhere between $3 - $8 Amazon. The 3D printed equivalent costs about 60 cents for a pair. So the cost basically reduced about 10 times the commercial equivalent.
References
- Dr. Greshenson's Lab for measurements.