Grout Trowel

MOST Delta filament as guide.JPG This page was part of an MTU course MY4777/MY5777/EE4777/EE5777: Open-source 3-D printing

Please leave comments using the discussion tab. The course runs in the Fall semester. It is not open edit.

Grout TrowelEdit

Project developed by Eric Hecht
This OSAT has been designed but not yet tested - use at own risk.
This OSAT has been prototyped.
This OSAT has been modeled.


   When spreading grout for tiling in areas like the kitchen or bathroom a normal tool may prove to be to large and unwieldy. My landlord asked for a cheap 3D printable tool that could fufill three tasks. The first main taks and what this tool is made for is spreading grout for tiling. However there are two other functions that you can use this for: smoothing concrete, and spackling. Those secondary applications won't work as well as a dedicated tool but this tool can still perform them. And as a bonus function you can table sandpaper to the bottom of this and use it as a sanding aparatues if you are lacking a powersander!

Dimensions: This is a small trowel designed for tight areas. The notches are .25in by .25in. LxW 6inx3in

A comparable trowel can be found here: [1]


Bill of MaterialsEdit

CAD files of parts Files found here



Purchased materials

  • 1kg of White PLA Filament

Tools needed for fabrication of the OSATEdit

  1. MOST Delta RepRap

Skills and Knowledge Necessary to Make the OSATEdit

  • N/A

Technical Specifications and Assembly InstructionsEdit

-Overall tool base dimensions Length and Width are 6in by 3in.

- The Grout Trowel

  • Layer Height: 0.15 mm
  • Top/Bottom layer thickness: 0.75 mm
  • Shell Thickness: 2
  • Fill Density: 100%
  • Printer Speed: 30 mm/s
  • Travel Speed: 50 mm/s

- Print time: 4 hours and 36 min with a raft, or 3 hours 29 min without a raft.


  • N/A

Common Problems and SolutionsEdit

  • If printed without a raft the corners may warp upwards due to heat and not enough proper adhesion to the base. Either add a raft of go more carefully over the surface area with glue.

Cost savingsEdit

  • 61 g of PLA filament were used which was a total cost of $1.20 at $20.12 for 1 kg of PLA filament
  • Grout Trowel can range in price from $5.00 to $25.00
  • The cost savings would be $3.80 to $23.80
  • The cost savings in percent would be 76% to 95.2%