Prototype Gigabot X printer user guide
This guide will walk through the steps to successfully operate the prototype Gigabot X from Re3D.
Printable Materials
So far, the Gigabot X has been tested and proven to work with the following pellets:
Virgin PLA, with MasterBatch Mixing
Recycled PLA from failed 3D Prints
Recycled ABS
Recycled PET
Recycled Polycarbonate
Recycled ASA
Recycled Polypropylene
How to use
Power and Lights
Interface
The interface is just like any other RepRap 3D Printer. It does use a mini SD card instead of a full size one however. Also there are two extruders, extruder one is for the bottom heater and extruder two is for the top heater on the extruder.
Slicing
Build size: 560 X 710 X 600 (mm)
Extruders: 2
Heated Bed: Enable
Enable Cooling: Off
Nozzle Diameter: 1.75mm
Retraction: 14mm
Retraction Speed: 20mm/s