No edit summary |
No edit summary |
||
Line 7: | Line 7: | ||
These parts can be found at [http://www.thingiverse.com/thing:575388 thingiverse] | These parts can be found at [http://www.thingiverse.com/thing:575388 thingiverse] | ||
====Parts Needed==== | ====Parts Needed==== | ||
In order to create this holder you will need to print off the following parts | In order to create this holder you will need to print off the following parts | ||
The fill of the parts can be fairly low (10%-15%) | The fill of the parts can be fairly low (10%-15%) | ||
Line 16: | Line 13: | ||
*4-pins | *4-pins | ||
*4 bushings | *4 bushings | ||
==tools needed== | |||
*most delta 3_d printer or similar model | |||
*PLA filiment | |||
====Part Assembly==== | ====Part Assembly==== | ||
Line 31: | Line 31: | ||
|File:Spool holder.JPG|completed spool holder | |File:Spool holder.JPG|completed spool holder | ||
}} | }} | ||
{{Category:777}} |
Revision as of 13:49, 11 December 2014
Fully adjustable, fully printable filament spool holder
This is a fully adjustable, fully printable spool holder, just as the title says.
Instructions
These parts can be found at thingiverse
Parts Needed
In order to create this holder you will need to print off the following parts The fill of the parts can be fairly low (10%-15%)
- 1-Base
- 2-Movable parts
- 4-pins
- 4 bushings
tools needed
- most delta 3_d printer or similar model
- PLA filiment
Part Assembly
To Begin
- place the pins into all of the bushings like figure 1 shows
- next place the pin bushing assembly into the moving part as figure 2 shows, depending on your filament the pin may need to be moved into a different spot.
- If desired, screw the base to desired location using the tabs on the side of the base. This is not necessary.
- Place the movable part assembly into the base