No edit summary |
No edit summary |
||
Line 3: | Line 3: | ||
==Introduction== | ==Introduction== | ||
This page is dedicated to describing the proper operational procedures for successful prints on the Gigabot utilizing Franklin firmware. Currently, the following pages exists in dedication to either Franklin and/or the GigabotHX. | |||
* [[Franklin]] | |||
* [[Franklin:MOST]] | |||
* [[GigabotHX]] | |||
==Procedures== | ==Procedures== | ||
Line 11: | Line 15: | ||
==Background / Reference Information== | ==Background / Reference Information== | ||
==Relevant Publications | ==Relevant Publications== |
Revision as of 01:59, 9 May 2016
Introduction
This page is dedicated to describing the proper operational procedures for successful prints on the Gigabot utilizing Franklin firmware. Currently, the following pages exists in dedication to either Franklin and/or the GigabotHX.
Procedures
- Connecting Printer to Franklin
- Initial Set/Up
- Uploading Files