Field Ready Design - Nebuliser

Nebuliser Connector

Project developed by [User:fordahl|Joey Fordahl]

Template:Statusboxtop Template:Status-design Template:Status-prototype You can help Appropedia by contributing to the next step in this OSAT's status. Template:Boxbottom

Abstract

• Sunil works as a Biomedical Engineer at Grande International Hospital, Kathmandu. A piece of equipment that he repeatedly sees in the engineering department is the nebuliser compressor. A nebuliser works by using compressed air to convert liquid medicine to an aerosol that can be inhaled by the patient. However, the plastic connector which attaches the medication tube to the compressor keeps breaking [1]

• Once a new hole is drilled through the nebuliser's exterior using a 12 mm drill bit, my connector will slide into the hole and be fastened with a 3d-printed nut. My connector was designed using FreeCAD from the dimensions provided by the site. I used the threaded portion of an M12-1.75 bolt that I pulled from Mcmaster.com. The nut stl file is also from Mcmaster.

Bill of Materials

• BOM - https://www.youmagine.com/designs/nebuliser-connector

1. 1. Connector
   2. 3D-printed 12mm-1.75 flange nut (Mcmaster STEP file)

Tools needed for fabrication of the OSAT

1. MOST Delta RepRap or similar RepRap 3-D printer
2. 1.75 mm PLA

Skills and Knowledge Necessary to Make the OSAT

• All you need is a 3D printer and slicing software for the STL's provided
• If you would like to modify the design, you can download FreeCAD [2]

Technical Specifications and Assembly Instructions

1. Both the connector and nut were printed in under 1 hour
2. The connector file should be printed with Support Type: Touching Buildplate (60 degree overhang)
3. Both files were printed at 0.1 mm layer height, but could be printed at .25 mm if desired.