Template:115inprogress

Introduction

Figure 1. The 60ft diameter primary clarifier tank at the Arcata plant.

After passing through the Headworks where large solids, objects and particles are removed, the wastewater moves on to the primary clarifiers. Primary clarifiers, also known as sedimentation tanks, are used in wastewater treatment plants to remove suspended solids from the wastewater being processed. The Arcata Wastewater Treatment Plant uses two clarifiers, one 26 foot diameter tank and one 60 foot diameter tank Figure 1. During a large storm, a much larger volume of water is processed by the clarifiers. If only the 60 foot clarifier was used, the retention time of the wastewater would be too short and the effluent would still contain large amounts of solid waste. The Arcata Wastewater Treatment Plant has the second, smaller clarifier to supplement the larger clarifier during such an event. Also, the 26 foot clarifier can be used independently while the 60 foot clarifier is being repaired.


Clarifier's

File:Clarifier Drawing (800pix).gif
Figure 2. [1] Cross-sectional diagram of a primary clarifier.
Figure 1. The influent well in the center of the clarifier.

Influent

Wastewater enters the clarifier through the influent well Figure 1 in the center of the tank. The influent well contains a series of baffles which reduce the velocity of the influent as it enters the clarifier; this is to prevent Short-Circuiting[2]. Short-Circuiting can occur when the water inside the clarifier gets disturbed and mixes, creating lower retention times and allowing solid waste to exit the clarifier along with the effluent.


Figure 3. The surface skimmer.

Settling

Once the influent enters the tank it's velocity begins to decrease, once the velocity decreases to 0.01-0.03 feet/second[3], suspended solids begin to settle out of the water; the denser solids (sludge) settle to the bottom of the tank and less dense solids (scum) and oils float to the surface. In the 60 foot clarifier at the Arcata Wastewater Treatmen Plant it takes 3.8 hours[4] for the solid waste to settle out. After 3.8 hours; up to 95% of the settleable solids, 60% of the suspended solids, and 40% of the BOD will have been removed from the wastewater[5].

Scum

The floating scum is skimmed off of the surface by a large rotating arm called the surface skimmer Figure 3. Once collected by the surface skimmer the scum is deposited into the scum trough and is transported to a storage container alongside the clarifier Figure 4. Once the storage container is filled, the scum will be disposed of in a landfill.

Figure 4. Floating solids and oils are deposited into this dumpster after being skimmed off of the surface.

Sludge

The sludge on the bottom of the tank gets collected by rotating collector arms which moves the sludge to the center of the tank. Once the sludge collects at the bottom of the tank it gets pumped to the digester to be processed and converted into biogas and compost.

Effluent

Figure 5. Effluent flowing though weirs and exiting through the effluent pipe.



MORE TEXT WILL GO HERE


Links


References


Cookies help us deliver our services. By using our services, you agree to our use of cookies.