Line 59: Line 59:
File:Motor and some wiring.jpg|Motor and some wiring and pillow bearing - right.  Also note the small block of wood which helps to align the threaded rod with the motor.
File:Motor and some wiring.jpg|Motor and some wiring and pillow bearing - right.  Also note the small block of wood which helps to align the threaded rod with the motor.
File:Motor_and_wiring.jpg|Motor and more wiring with cotter pin mod.
File:Motor_and_wiring.jpg|Motor and more wiring with cotter pin mod.
File:Motor mount box end.jpg|Motor mount galvanized steel box - side view
File:Motor mount box end.jpg|Motor mount galvanized steel box - side view.  The front is on the left.
File:New aluminum rotating tube 1.jpeg|New aluminum rotating tube placed lower.  This apparently solves our "rod connection" challenge.
File:New aluminum rotating tube 1.jpeg|New aluminum rotating tube placed lower.  This apparently solves our "rod connection" challenge.
File:Connections in the motor area.jpeg|How the aluminum rod and support are connected to the motor area.
File:Connections in the motor area.jpeg|How the aluminum rod and support are connected to the motor area.

Revision as of 00:04, 9 November 2016

Main Photo - May, 2014
To finish building an Open Source parabolic hot water heater.

Here we have the different parts of the project design, including some photos

  • Collector
    • Metallic Structure
    • Reflector area
  • Motor area
    • Motor mounting - Metallic structure
    • Electrical
  • Electronics

Collector

Collector Photos

Collector Drawings

Collector Comments

8 Nov. 2016 Just thought i'd add that the Jalero was pretty complicated. We decided to experiment with just the bent steel rod resting and rotating against a clamp.

i like the jalero: it's homemade and pretty inexpensive, and uses those round things with a set screw so the distance can be adjusted; it's all stainless steel and aluminum.

Motor Area

Motor Area Photos

                   ____________________________________________________________ 9 ________________________________________________________________________

Motor Area Drawings

Motor Area Comments

In the photo of the side view of the motor mount, the far right cable has been eliminated because the wire now goes up the inside of the rotator rod which has the electronic sensor at the top.

The other three holes are, top to bottom: switch, power and power cable for small pump at foot of collector.

Motor support box - right side now only has three holes. See above.

Motor support box - front - inside: This needs additional items: the inverter, etc.

Electronics

Electronic Photos

Electronics Drawings

Electronics Comments?

Here's where to comment on the electronics area - lol!

March 2015 - Well, it looks like the problem was one of angles. The relation between the long connecting rod and the two shorter, vertical ones which connect to the collector and motor needs to form a parallelogram. So we lowered the connection point on the motor area to make sure it was the same distance from the ground as the one that connects to the collector. Since we lowereed the connection point, we added an aluminum rod to the motor area frame and used our 7" bolt. We now see that a 4" bolt will probably do.

First comment... We have switched out the 6" bolt to a 7" one. When we were using the previous design, the assembly wouldn't bind, but now it does, so much so that it manages to bend the 1/2" threaded rod. We are at a loss to explain what is happening here. Anyone have an idea?

Misc.

For additional information, please feel free to contact Fred Frazelle at info@fundacionanisa.org

Return to Home Page: http://www.appropedia.org/Parabolic_Solar_Hot_Water_Heater

Cookies help us deliver our services. By using our services, you agree to our use of cookies.