Get our free book (in Spanish or English) on rainwater now - To Catch the Rain.

Difference between revisions of "Actually Functional 2" Wafer Dipper for Schott Duran 250 ml beaker"

From Appropedia
Jump to: navigation, search
(Design notes)
(Design and use)
Line 29: Line 29:
  
  
== Design and use ==
+
== Design ==
  
 
The design can be found here: [https://3dprint.nih.gov/discover/3dpx-008194 Parametric wafer dipper]
 
The design can be found here: [https://3dprint.nih.gov/discover/3dpx-008194 Parametric wafer dipper]

Revision as of 10:58, 26 October 2017

Finished print, with one 2" sapphire wafer inserted.


The design can be found here: Parametric wafer dipper


Motivation for this project is that outside industruial semiconductor production the processed wafer quantities are small. In academia it is common to process 1-3 wafers at a time. Therefore wet etching and other dipping is often done in a beaker. It is quite difficult to find small dippers for 2 inch wafers that fit into a standard 250 ml beaker.


This 2 inch wafer dipper is designed to fit into a 250 ml Schott Duran beaker. Number of wafers that can be fitted are automatically calculated and taken into account. The user needs to think only the size of his or her beaker and ofcourse the wafer dimensions.




Designer

Christoffer Kauppinen' Aalto University, Department of Electronics and Nanoengineering


Design

The design can be found here: Parametric wafer dipper


The code is parametric and the comments should be enought to edit the design as one wishes.


I recommend printing the dipper upright. The Lulzbot TAZ6 printed this one nicely.

CAD images

Design notes

Check chemical compatibility of your used materials before printing! No materials recommendations are given on purpose. Check the printing material, the used fluids and the samples to be inserted so that no unwanted reactions occur.

The wafers only touch the dipper at the edges, where the edge exclusion anyway limits the usefulness of the edge part. The bottom has a nice drain for the fluid to drain out.

The wafers are nicely fixed in the dipper. Accidental dropping of the wafers from the dipper is almost impossible.


The dipper fits just right.

Savings per print

Now this is a difficult number to give as I have not found similar dippers. A Korean supplier says the price is roughly ~260€ for a 2" Teflon dipper. As the design presented in this wiki is customized, at least same price can be used for savings calculations, assuming the used material isa similar to Teflon.

With 100% fill 3.8 m of 2.85 mm filament is required. The chosen material affects the savings, but assuming a very bad case where the print requires one whole spool of 1.75mm FEP filament which cost ~100€,

the savings are at least ~160€/print.