Device
7up
Bike 7up.jpeg
Description Bicycle part
Intended use hobbyism, education
Keywords 3D printing, bike part, bicycle
Authors Yan Guo
Project status prototype
Project was made? Yes
Project was made independently? No
Countries of design United States
Project affiliation Category:MTU
Category:MOST
Main materials Plastic
Estimated cost USD 2.00
SDG SDG11 Sustainable cities and communities
Documentation data
Language English
Manifest data
Language English
Updated 2020-06-04
Author Kathy Nativi
Author affiliation Appropedia
Author email info@appropedia.org

GalleryEdit

Bicycle part: 7upEdit

Project developed by Yan Guo(talk)


AbstractEdit

  1. The project was offered from Dr. John Gershenson, part of his lab for measurements.
  2. Picture of completed print  

Bill of MaterialsEdit

  1. Only plastics and 3D-printer needed.
    1. link to all source files
      1. File:7up 1.scad
      2. File:Top part.scad
      3. File:Down part.scad
    2. link to all STLs
      1. File:7up 1.stl
      2. File:Top part.stl
      3. File:Down part.stl

Tools needed for fabrication of the OSATEdit

  1. MOST Delta RepRap or similar RepRap 3-D printer

Skills and Knowledge Necessary to Make the OSATEdit

  • basic measurement

Technical Specifications and Assembly InstructionsEdit

  1. Print the top part and down part separately.
  2. Joint them by heater through the edge of each part.
  3. printing time for each part is about 1.5 hours.
  4. Jointing time is about 15 min.


Common Problems and SolutionsEdit

  • Carefully when using the heater, don't burn yourself :)

Cost savingsEdit

  • If your solution is not a low cost one then it is not really appropriate.
  1. Estimate your costs: about 2 dollar.
  2. Find a commercial equivalent: about 10 dollar because of the material.
  3. 8$ savings and 80% savings
MediaWiki spam blocked by CleanTalk.