We continue to develop resources related to the COVID-19 pandemic. See COVID-19 initiatives on Appropedia for more information.
3D Printed Gravity Light
|Description||This project was to replicate the already produced gravity light into the 3D Printed and open source world.|
|Intended use||development, education|
|Keywords||3D printing, gravity light|
|Appropedia user||User:Josh Mucinski|
|Project was made||Yes|
|Date of publication|
|Countries of design|
|SDG||Sustainable Development Goal 9, Sustainable Development Goal 11|
|Preliminary Student Design Warning|
|Note that this page is a preliminary student design and has not been vetted.|
|Care should be taken to read critically and weigh the evidence.|
|Remember non-tested and vetted designs should not be relied on, especially in matters of health and safety. Recommendations to improve this project follow:|
- as printed gears to tight to function - must increase tolerances to make functional
OSAT 3D Printed Gravity Light
Project developed by Josh Mucinski and John Risch
- This project was to replicate the already produced gravity light into the 3D Printed and open source world.
History of the Project
So the project was taken from Gravity Light, and the goal was to turn this product in to a 3D printable product. The project seems so simple but was very hard to get working. We first started off gather some initial data, and it seem like we were going to need a gear reduction of 1:500 which is a crazy amount.
So we started off with a small Planetary hand crank light, following the directions and scaling the part by 150% and upping the infill. We had some small success, but ultimately it failed due to high stress in the gears.
Bill of Materials
From 3d Printed Gears
- 1x Front
- 1x Ring
- 1x Carrier
- 3x Planets
- 3x Washers
- 1x Custom Shaft
- 1x Bottom Servo Holder
- 1x Top Servo Holder
Common Problems and Solutions
Most of our issues were with friction, so that is the reason we could not add more than on planetary gear sets.
With it still being in the development phase, and for 50 USD you will get one. Printing this cost upwards of 10 dollars and some parts found in the IEEE lab..