3D printed gravity light: Difference between revisions

This page was part of an MTU course MSE4777 OA and MSE4777 OB/MSE5777/EE4777/EE5777: Open-source 3-D printingPlease leave comments using the talk page. The course runs in the Fall semester. It is not open edit.Read more...

Preliminary Student Design WarningThis page is a preliminary student design and has not been vetted. Care should be taken to read critically and weigh the evidence. Remember non-tested and vetted designs should not be relied on, especially in matters of health and safety.Read more...

• as printed gears to tight to function - must increase tolerances to make functional

OSAT 3D Printed Gravity Light

Project developed by Josh Mucinski and John Risch

Template:Statusboxtop Template:Status-design Template:Status-prototype You can help Appropedia by contributing to the next step in this OSAT's status. Template:Boxbottom

Abstract

1. This project was to replicate the already produced gravity light into the 3D Printed and open source world.

• OSAT 3D Printed Gravity Light
• 
• 
• 

History of the Project

So the project was taken from Gravity Light, and the goal was to turn this product in to a 3D printable product. The project seems so simple but was very hard to get working. We first started off gather some initial data, and it seem like we were going to need a gear reduction of 1:500 which is a crazy amount.

So we started off with a small Planetary hand crank light, following the directions and scaling the part by 150% and upping the infill. We had some small success, but ultimately it failed due to high stress in the gears.

So we then moved to another larger sized planetary gears. At this stage this is our working model, but still has a long way to go. So this prototype is a proof of concept, gravity light.

Bill of Materials

From 3d Printed Gears

1. 1x Front
2. 1x Ring
3. 1x Carrier
4. 3x Planets
5. 3x Washers
6. 1x Custom Shaft
7. 1x Bottom Servo Holder
8. 1x Top Servo Holder

Common Problems and Solutions

Most of our issues were with friction, so that is the reason we could not add more than on planetary gear sets.

Cost savings

With it still being in the development phase, and for 50 USD you will get one. Printing this cost upwards of 10 dollars and some parts found in the IEEE lab..