Get our free book (in Spanish or English) on rainwater now - To Catch the Rain.

Changes

Jump to navigation Jump to search

Scrub Brush

56 bytes added, 00:42, 9 December 2019
no edit summary
== Technical Specifications and Assembly Instructions==
#Download desired .stls from thingiverse.com
##OSAT_scrub_brush_2.stl is a full size scrub brush# Cura Print Settings [[Image:OSAT_brush_print.jpg|200px|right|thumb| Finished full size brush print]][[Image:OSAT_brush_prep.jpg|200px|right|thumb|Tools used to cut brushes apart]][[Image:OSAT_brush_cut.jpg|200px|right|thumb|Two brushes successfully cut apart]]
## Set layer height to 0.3 mm if using uncostumized bristles
##1.0 wall thickness
###Bridge wall flow: 105%
###Bridge fan speed: 100%
##Watch first couple layers to ensure bristles are printing properly[[Image:OSAT_brush_prep.jpg|200px|right|thumb|Tools to cut brushes apart|]]
###Try increasing bridge wall flow or decrease bridge wall speed if they seem disconnected from one side
# The smaller test brush OSAT_scrub_brush_1.stl from thingivrese.com takes ~3 hours to print
##Use it to optimize the bridging settings
#The fullsize brush OSAT_scrub_brush_2.stl from thingivrese.com takes ~7 hours 45 minutes to print
# Cutting the brushes apart takes 10-15 minutes [[Image:OSAT_brush_cut.jpg|200px|right|thumb|Two brushes successfully cut apart]]
##A sharp tool ensure fewer bristles will be broken during the process
##Avoid sawing motions to prevent breaking bristles

Navigation menu