EditEdit source

☀️ Get the new solar book at our Kickstarter for To Catch the Sun.

Changes

From Appropedia
Line 106: Line 106:     
== Technical Specifications and Assembly Instructions==
 
== Technical Specifications and Assembly Instructions==
# Customize & Print 2 copies of the Hemostats
+
# Download and print the plastic components listed in the bill of materials
* It is recommended to print around 30 mm/s with a 100% infill
+
* Recommended: Print with a 100% infill at 0.25mm layer thickness or less, print speed may vary depending on printer
# Orient the two printed pieces so that:
+
# Clean burrs and excess plastic from parts that may be remaining from print
## The holes align
+
# Align the corresponding components from the bill of materials to the pictures posted below while ensuring:
## The finger holes of the prints are on opposite sides
+
## All holes align
## Locking wedges are pointing toward each other for proper engagement
+
## All gears mesh together
# Insert bolt into hole. (Direction does not matter)
+
## L
# Engage the nut onto the bolt.
+
# Assemble Fasteners so that the head of the screws are on the face of the indicator and washers are on both mating surfaces
# Tighten with very little force using a screw driver and a wrench. (Over tightening will the limit the ability of the hemostats.
+
#  
 +
# Lightly tighten fasteners so that gears spin freely with minimal slop
 +
# Assemble needle so that needle is spaced away from dial face
 +
 
 
== Common Problems and Solutions==
 
== Common Problems and Solutions==
 
* Make sure that the wedges that lock into each other are both wide enough and deep enough so that they do not break when you try and lock the Hemostats down.
 
* Make sure that the wedges that lock into each other are both wide enough and deep enough so that they do not break when you try and lock the Hemostats down.
85

edits