Changes

Jump to navigation Jump to search
Line 24: Line 24:  
== Technical Specifications and Assembly Instructions==
 
== Technical Specifications and Assembly Instructions==
   −
# This print should take about 4 hours (I printed three different prints - one with 3 pieces, one with 2, and one with 1). These could all be printed in one go, reducing print time drastically.
+
* This print should take about 4 hours (I printed three different prints - one with 3 pieces, one with 2, and one with 1). These could all be printed in one go, reducing print time drastically.
# Assembly should take no more than 5 to 10 minutes.
+
* Assembly should take no more than 5 to 10 minutes.
# 1. Print all part at .1 mm resolution (lower resolution may still work, but have not been tested)
+
# Print all part at .1 mm resolution (lower resolution may still work, but have not been tested)
# 2. All parts should be printed vertically. The end-handle should be printed with the hole on the narrow end facing up.
+
# All parts should be printed vertically. The end-handle should be printed with the hole on the narrow end facing up.
# 3. Insert spring-slide over the drill body. After a few rotations, it should revolve smoothly.
+
# Insert spring-slide over the drill body. After a few rotations, it should revolve smoothly.
# 4. Place the chuck-jaws into the drill body with the jaw-cover screwing into the body over the chuck-jaws
+
# Place the chuck-jaws into the drill body with the jaw-cover screwing into the body over the chuck-jaws
## a. If a spring is being used, place the spring [https://www.mcmaster.com/#9657k439/=178iw9i Spring sized for this print] over the drill body before securing the jaw-cover
+
## If a spring is being used, place the spring [https://www.mcmaster.com/#9657k439/=178iw9i Spring sized for this print] over the drill body before securing the jaw-cover
# 5. Attach the end handle to the spring-slide
+
# Attach the end handle to the spring-slide
    
=== Common Problems and Solutions===
 
=== Common Problems and Solutions===
84

edits

Navigation menu